Sleep / Hibernation / Resume
Cannot enter sleep or hibernation.
Remove USB devices temporarily. If the problem persists, restart the computer.
It may take 1 or 2 minutes to enter sleep or hibernation.
The computer does not enter sleep or hibernation immediatelyafter resuming. Wait approx-
imately 1 minute.
Cannot enter sleep or hibernation auto-
matically.
Disconnect peripheraldevices.
If you connect to a network using wireless LAN function, select the profile and connect to the
access point ( Disabling/Enabling Wireless Communication).
If you do not use wireless LAN function, turn off wireless LAN function ( Disabling/Enabling
Wireless Communication).
Make sure that you are not using any software that regularly accesses the flash memory.
The computer does not resume.
If you press and hold the power switch for 4 seconds or longer, the power willbe
turned off forcibly and the computer will not resume. In thiscase, all unsaved data will be lost.
You disconnected the AC adaptor and the batterypackwhile the computer was in sleep. If the
computer'spower supplyis disconnected in sleep, unsaved data will be lost and the computer
will not resume.
The battery is exhausted. Sleep and hibernation consumes some power.
An error may occur when the computer automatically entersthe sleep or hibernation mode
while the screensaver isactive. In this case, turn off the screensaver or change the pattern of
the screensaver.
[Enter Password] does not appear when
resuming from sleep/hibernation.
Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility (
Setup Utility).
The Windows password can be used instead of the password set in the Setup Utility.
Add a password, and set up the following.
1.
Touch (Settings) - [Accounts].
2. Touch [Sign-in options], and touch [Add] under “Password”.
3. Create a password.
4. Touch .[Next].
5. Select [When PC wakes up from sleep] under “Require sign-in”.
Display
No display.
The displayis turned off bythe power-saving function.
Touch the screen.
The computer entered sleep or hibernation by the power-saving function. To resume, pressthe
power switch .
When using an external display,
Check the cable connection.
Turn on the display.
Check the settingsof external display.
- 113 -
To Next Page
Loading...
