Changing settings
1.
Touch (Panasonic PC Settings Utility) - (Settings) - (Touch Screen).
2. Touch [Advanced Settings] under “Touch Operation Support”.
3. Adjust each setting.
A. Use the slider to change the zoom ratio of the window (4 levels in 0.5x increments).
B. If you clear the checkbox, the zoom window will continue to be displayed when you tap inside the zoom window.
If you select the checkbox, the zoom window will close when you tap inside the zoom window.
C. If you select the [Display Operation Guides] checkboxand touch [OK] to close the window, operation guides will appear the next time you
perform a two-finger tap after signing in.
D. Touch thisto restore changed values to default settings.
4. Touch [OK].
This completes settings adjustment.
N O T E
n Specifying a zoom ratio other than 2.0xor 3.0x may cause text in the zoom window to appear unclear.
n When the setting window isdisplayed, the zoom window will not be displayed.
Disabling Touch Operation Support
1.
Touch (Panasonic PC Settings Utility) - (Settings) - (Touch Screen).
2. To disable “Touch Operation Support”, remove a checkmark to “Support touch operation”.
- 23 -
To Next Page
Loading...
