Do not applytoo much pressure when operating the screen.
Only a light touch is required to operate the screen. Applying too much pressure may damage the surface.
Handling the screen
Do not applystrong pressure to the screen outside of the LCD display.
Applying strong pressure to the screen outside of the display area may result in malfunctions or damage to the LCD screen.
Do not applyexcessive force to the screen.
Do not place any objectson the LCD screen. Any of the above may cause the screen glass to break, or may damage the LCD screen.
Operation response may be slower in low temperature environments.
The screen mayrespond to operations more slowly when using the computer in temperatures less than 5 °C {41°F}, but this is not a malfunction.
Response time will return to normalwhen the computer is returned to room temperature.
If the pointer jumps to a location other than where the screen was touched, or if the LCD resolution changes, recalibrate the screen.
Perform the procedure of “Calibrating the Screen”.
Handling the dedicated pen (optional)
Clean the dedicated pen tip and screen prior to operation.
Foreign particles can scratch the screen and impede the operation of the dedicated pen.
Use onlythe dedicated pen to touch the screen.
Using it for any other purpose may damage the dedicated pen and result in scratcheson the screen.
The pointer cannot follow the dedicated pen movement if you move the dedicated pen too quickly.
When using peripheral devices
Follow these instructions and this Manual to avoid any damage to the devices. Carefully read the instruction manuals of the peripheral devices.
Use the peripheraldevices conforming to the computer’sspecifications.
Connect to the connectors in the correct direction.
If it is hard to insert, do not try forcibly but check the connector’s shape, direction, alignment of pins, etc.
If screwsare included, fasten them securely.
Remove the cables when you carry the computer. Do not pull the cablesforcibly.
Preventing your computer from unauthorized use via wireless LAN/Bluetooth/wireless WAN
<Only for modelwith wireless LAN/Bluetooth/wireless WAN>
Before using wireless LAN/Bluetooth/wireless WAN, make the appropriate securitysettings such asdata encryption.
Battery Recalibration
The battery recalibration may take a long time due to the large battery capacity. This is not a malfunction.
<When performing “Battery Recalibration” after shutting down Windows>
<Only for FZ-M1J-series models>
Full charge: Approximately 2.5 hours (with FZ-VZSU94W) / Approximately 4.5 hours (with FZ-VZSU95W (optional)
Complete discharge: Approximately2.5 hours (with FZ-VZSU94W) / Approximately 5.0 hours (with FZ-VZSU95W (optional)
<Only for FZ-M1G-series models>
Full charge: Approximately 2.5 hours (with FZ-VZSU94W) / Approximately 4.5 hours (with FZ-VZSU95W (optional)
Complete discharge: Approximately4.0 hours (with FZ-VZSU94W) / Approximately 9.0 hours (with FZ-VZSU95W (optional)
When performing “Battery Recalibration” without shutting down Windows, it may take more time to charge / discharge.
Battery duration
Note that the computer consumes electricityeven when the computer power is off. If the batterypackis fully charged, the battery will fully discharge in the
following period of time:
- 69 -
To Next Page
Loading...
