Setting item
Description
Tab name Settings
Path preprocessors -
[Not supported]
Use this item to perform preprocessing on devices for which
interpolation control is to be performed. Because this mode is not
supported by the GM1 controller
, do not use.
Preinterpolation
Cycle time
Check that the time matches the time displayed in the
"MotionT
ask" window.
Velocity mode
[Unchangeable]
Check that the mode is set to "T
rapezoid".
Maximum jerk
Specify a maximum value for jerk during interpolation control
operation.
Table editor -
This tab is used to perform CNC in "table format". Because the
GM1 controller uses G-code (Din66025), there is no need to
configure settings in this window
.
■
"CNC Program" - "Properties"
In the Device tree of GM Programmer
, right-click Application>CNC_Sample>Properties in
this order.
11.5 Multi-axis Operation
11-58 WUME-GM1RTXOP-01
To Next Page
Loading...
