7
VQT4G75
∫ Attaching the Lens Hood
(Supplied Accessory)
1
Align the fitting mark
E
on the lens
hood with the mark on the tip of the lens.
2 Turn the lens hood in the direction of
the arrow until it stops, and align the
stop mark F on the lens hood with
the mark on the tip of the lens.
∫ Temporarily Storing the Lens Hood
1 Turn the lens hood in the
direction of the arrow to
detach it.
2 Reverse the lens hood
and then attach it in the
same way as shown
previously.
• When taking pictures with
the flash with the lens hood
attached, the lower portion of
the screen may turn dark (vignetting effect) and
the control of the flash may be disabled because
the photo flash may be obscured by the lens
hood. We recommend detaching the lens hood.
• When using the AF assist lamp in the dark,
detach the lens hood.
∫ Attaching Filters
≥ Vignetting may occur if using 2 or more
MC protectors (optional: DMW-LMCH58),
PL filters (optional: DMW-LPL58) or ND filters
(optional: DMW-LND58), or if using thick
protectors and/or filters.
≥ The filter may become impossible to remove if
excessively tightened, so please refrain from
tightening it too strongly.
≥ It is possible to attach the lens cap with the filter
already attached.
≥ You cannot attach a conversion lens or adaptor to
this lens. A filter may be used, but attaching any
other element may cause damage to the lens.
VQT4G75_E.book 7 ページ ２０１２年９月１１日 火曜日 午後７時３５分
To Next Page
Loading...
