95
VQT3Y48
Deleting part of a scene (AVCHD)
Unnecessary part of an AVCHD scene can be deleted.
The deleted scenes cannot be restored.
≥ Change the mode to and touch the play mode select icon. Then, select the
AVCHD scene. (l 31)
1 Select the menu.
2 Touch the scene with a part to delete.
3 Set the section to delete by touching and
sliding the top and bottom section selection
buttons .
≥ It is convenient to use Slow-motion Playback and Frame-by-
frame Playback. (l 80)
4 Touch [ENTER].
5 Confirm (play back) the scene after editing by touching [YES].
≥ A confirmation message appears when [NO] is touched. Proceed to Step 7.
6 Stop the playback.
≥ A confirmation message appears.
7 Touch [ENTER].
≥ Repeat steps 2-7 to continuously delete parts from other scenes.
≥ Deleting of part cannot be performed when there are 99 scenes in a single date.
≥ It may not be possible to delete part of a scene with a short recording time.
≥ The scene will be divided into two scenes when middle part of a scene is deleted.
≥ The relay information is deleted when part of a scene that was relay recorded is deleted,
making it impossible to perform the Relay scene combining. (l 99)
: [EDIT SCENE] # [SECTION DELETE]
HC-V700M&V700_EB-VQT3Y48_mst.book 95 ページ ２０１１年１２月２６日 月曜日 午前９時３６分
To Next Page
Loading...
