- 75 -
Message is displayed when this unit is moved rapidly.
When “CAMERA PANNING IS TOO FAST.” appears, move the unit slowly while recording.
≥ Message will not appear while pausing the recording. (Message will appear even if it is pausing
the recording if [DEMO MODE] is set to [ON].)
This will reduce the wind noise coming into the built-in microphones while maintaining the realism.
≥ Switch to Manual Mode. (l 57)
≥ When [Strong] is set, you can check how effectively the wind noise is reduced with the icon
displayed on the screen. In descending order of the strength of the reduction effect, / /
/ is displayed.
≥ When [Normal] is set, will be displayed on the screen.
≥ This function’s default setting is [Normal].
≥ When switching to Intelligent Auto Mode or Intelligent Auto Plus Mode, [Wind Noise Canceler] is
set to [Strong], and the setting cannot be changed.
≥ You may not see the full effect depending on the recording conditions.
Recording setting of the built-in microphone can be adjusted.
≥ [MIC SETUP] will become [STEREO MIC] when the [REC FORMAT] is set to [MP4/iFrame].
[SHOOTING GUIDE]
: [RECORD SETUP] # [SHOOTING GUIDE] # [ON]
[Wind Noise Canceler]
: [RECORD SETUP] # [Wind Noise Canceler] # desired setting
[Strong]: When a strong wind is detected, this option effectively reduces the
wind noise by minimizing the low-pitched sound.
[Normal]: This option extracts and reduces only the wind noise without
deteriorating the sound quality.
[OFF]: Cancel the setting.
[MIC SETUP]
: [RECORD SETUP] # [MIC SETUP] # desired setting
[STEREO MIC]: Sound from two directions is recorded in 2 ch by forward-facing
stereo microphones.
[ZOOM MIC]: Sound is recorded with changing the directionality in conjunction
with the zoom operation. Sounds near the front of the unit are
recorded more clearly if you zoom in (close-up) and surrounding
sounds are recorded more realistically if you zoom out (wide angle).
MENU
To Next Page
Loading...
