38
VQT2H62
Auto focus does not work correctly in the
following situations. Record pictures in the
manual focus mode.
jRecording distant and close-up objects at the
same time
jRecording a subject behind dirty or dusty
window
jRecording a subject that is surrounded by
objects with glossy surfaces or by highly
reflective objects
jRecording a subject in dark surroundings
jRecording a fast-moving subject
jRecording a subject with little contrast
This unit will resume recording pause mode
about 0.6 seconds after the LCD monitor is
reopened or the viewfinder is extended.
≥ When in quick start standby mode about
70% of the power used in recording pause
mode is being consumed, so the recording
time will be reduced.
≥ Start time will not shorten if there is no SD card
inserted.
Start time will be shorten if the [Built-in
Memory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
¬Change the mode to or .
1 Select the menu. (l 22)
2 Close the LCD monitor and
retract the viewfinder while the
mode is set to or .
The status indicator A flashes green and the unit
goes into quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the unit is
put into recording pause.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
junit is turned off
≥ Time for quick start will be more than
0.6 seconds slower when digital cinema is
used.
≥ Depending on the recording conditions, time
for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥ It may take some time for automatic white
balance to adjust.
≥ In the quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 25) is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and then
open it again.
≥ Quick start standby mode cannot be released
by the remote control. Turn the mode to OFF
when powering off.
The unit is put into recording pause approx.
1.9 seconds when the mode is set to or
from OFF.
¬Change the mode to or .
Select the menu. (l 22)
≥ This function’s default setting is [ON].
≥ Depending on the recording conditions, start
time may be longer than 1.9 seconds in still
picture recording mode.
≥ In the quick power on mode, the zoom
magnification becomes 1k.
Quick start
[SETUP] # [QUICK START] # [ON]
Quick power on
[SETUP] # [QUICK POWER ON] # [ON]
To Next Page
Loading...
