IP OUT1 (H.264/H.265) [FULL, Crop]
IP OUT2 (H.264/H.265) [FULL, Crop]
Makes the settings for FULL/Crop for images output to H.264/H.265/
M-JPEG transmission (LAN connector).
Setting specified in [IP OUT1 (H.264/H.265)] is applied to images
transmitted by each transmission CH1(H.264(1), H.265(1), JPEG(1)).
Setting specified in [IP OUT2 (H.264/H.265)] is applied to images
transmitted by each transmission CH2 to CH3(H.264(2) to (3),
H.265(2) to (3), JPEG(2) to (3)).
FULL FHD down-converted images are output as is without
cropping UHD images.
Crop Images with FHD cropped from UHD images are output.
The images output in this case are those with the crop
frame specified in [Crop Output Select].
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
When the [Streaming mode] on the web screen is [NDI|HX V2], [IP
OUT1 (H.264/H.265)] and [IP OUT2 (H.264/H.265)] will have a linked
operation.
Factory settings: Crop
Adjust
Crop Output Select [Yellow, Green, Magenta]
Make the settings for the crop frame images output to the 3G
SDI OUT1 connector, cropped images of SMPTE ST2110, High
bandwidth NDI images, and the LAN connector (H.264/H.265/
M-JPEG).
Yellow Output the yellow crop frame images.
Green Output the green crop frame images.
Magenta Output the magenta crop frame images.
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
Factory settings: Yellow
<NOTE>
• The color frame specified in [Crop Output Select] will be a deeper
shade when compared to other colors used for frames.
• Cropped images cannot be output with the 12G SDI OUT/SFP+
connector, 3G SDI OUT2/PM connector, HDMI connector, SMPTE
ST2110 MAIN images, or SMPTE ST2110 MONITOR images.
Crop Marker [Off, Yellow, Green, Magenta, Yellow+Green,
Yellow+Magenta, Green+Magenta, Yellow+Green+Magenta]
Make the settings for the crop frame displayed for images output
to the 3G SDI OUT1 connector, the 3G SDI OUT2/PM connector,
the MONITOR images of SMPTE ST2110, and the LAN connector
(H.264/H.265/M-JPEG).
Off Crop frame is not displayed.
Yellow Only a yellow crop frame is displayed.
Green Only a green crop frame is displayed.
Magenta Only a magenta crop frame is displayed.
Yellow+Green Yellow and green crop frames are displayed.
Yellow+
Magenta
Yellow and magenta crop frames are displayed.
Green+
Magenta
Green and magenta crop frames are displayed.
Yellow+
Green+
Magenta
Yellow, green, and magenta crop frames are displayed.
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
Factory settings: Yellow+Green+Magenta
Crop Zoom [OFF, ON]
Make settings about whether to run cropping that uses D-Zoom.
When [ON], you can set the Zoom magnification.
(→ “Crop Zoom Ratio”)
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
Factory settings: OFF
Zoom (Crop Zoom Ratio) [120.00% to 500.00%]
Specifies the size of the crop frame when [Crop Zoom] is [ON].
The crop zoom ratio can be specified between the range of 120.00%
to 500.00%, and the grain-size can be set in units of 10.00% from the
OSD menu.
The variable range of the setting value of this item, the crop frame
size, [Crop H Position] and [Crop V Position] is shown below.
Crop Zoom Ratio Crop frame size
Variable range
Crop H
Position
Crop V
Position
120.00% 3200×1800 0 to 640 0 to 360
200.00% 1920×1080 0 to 1920 0 to 1080
300.00% 1280×720 0 to 2560 0 to 1440
400.00% 960×540 0 to 2880 0 to 1620
500.00% 768×432 0 to 3072 0 to 1728
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
This is only enabled when [Crop Zoom] is set to [ON].
Factory settings: 200.00%
3G SDI1 OUT [FULL, Crop]
Make the settings for FULL/Crop for images output to the 3G SDI
OUT1 connector.
FULL FHD down-converted images are output as is without
cropping UHD images.
Crop Images with FHD cropped from UHD images are output.
The images output in this case are those with the crop
frame specified in [Crop Output Select].
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
Factory settings: Crop
NDI Out [FULL, Crop]
Makes the settings for
FULL/Crop
for images output to High bandwidth
NDI transmission.
FULL FHD down-converted images are output as is without
cropping UHD images.
Crop Images with FHD cropped from UHD images are output.
The images output in this case are those with the crop
frame specified in [Crop Output Select].
This is only enabled when [Crop Mode] is set to [Crop(720)] or
[Crop(1080)].
Factory settings: Crop
159
Web screen configurations (continued)
To Next Page
Loading...
