z RTSP
This performs settings related to the RTSP function. The RTSP function
sets the RTSP transmission port and RTSP request URL used during IP
image transmission.
The setting is confirmed with the [Set] button.
RTSP port [1 to 65535]
Sets the RTSP reception port no.
The following port numbers are used by the unit so they cannot be
used.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 546,
547, 995, 5960 to 5985, 7960 to 8060, 10669, 10670, 11900, 59000
to 61000
Factory settings: 554
RTSP request URL
Sets up the URL for RTSP when making IP image transmission
demands to this unit.
RTSP request URL H.264(1)
RTSP URL for H.264(1) image
transmission
RTSP request URL H.264(2)
RTSP URL for H.264(2) image
transmission
RTSP request URL H.264(3)
RTSP URL for H.264(3) image
transmission
RTSP request URL H.265(1)
RTSP URL for H.265(1) image
transmission
RTSP request URL H.265(2)
RTSP URL for H.265(2) image
transmission
Factory settings:
RTSP request URL H.264(1) MediaInput/h264/stream_1
RTSP request URL H.264(2) MediaInput/h264/stream_2
RTSP request URL H.264(3) MediaInput/h264/stream_3
RTSP request URL H.265(1) MediaInput/h265/stream_1
RTSP request URL H.265(2) MediaInput/h265/stream_2
• Up to 255 characters can be entered.
• The following characters can be displayed.
Numeric characters 0123456789
Alphabetical
characters (upper and
lower cases)
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
Symbols / - _
<NOTE>
• RTSP request URL cannot have the same URL.
z SNMP
Make SNMP functionality related settings. You can check the status of
the unit by using the SNMP manager to connect.
The setting is confirmed with the [Set] button.
SNMP [On, Off]
Sets whether to use the SNMP function.
Factory settings: Off
User name
Sets the user name used for user authentication.
You need to specify the same user name that you set here in the
SNMPv3 manager.
Maximum number
of characters
0 to 32 characters
Characters that
cannot be entered
Double-byte
Authentication
Sets the algorithm used for user authentication.
MD5 MD5 is used as the algorithm for user authentication.
SHA1 SHA1 is used as the algorithm for user authentication.
Factory settings: SHA1
Encryption method
Sets the encryption method used for communications.
DES
DES is used as the encrypted communication method for
SNMPv3.
AES
AES is used as the encrypted communication method for
SNMPv3.
Factory settings: AES
Password
Sets the password used for user authentication.
You need to specify the same password that you specified here in the
SNMPv3 manager.
Maximum number
of characters
When [Authentication] is set to [MD5]:
8 to 16 characters
When [Authentication] is set to [SHA1]:
8 to 20 characters
Characters that
cannot be entered
Double-byte
175
Web screen configurations (continued)
To Next Page
Loading...
