TRACKING DATA OUTPUT
Make settings related to the output of tracking data used in virtual studio
systems, etc. (→ page 71)
<NOTE>
• There is no tracking data output when [BASIC CONFIG] – [FORMAT]
is [1080/119.88p] or [1080/100p].
SERIAL [OFF, ON]
Set ON/OFF for the function which outputs the tracking data such as
Pan/Tilt/Zoom data via the serial output (RS-422) and synchronizes it
with the GENLOCK signal. (→ page 71)
<NOTE>
• The camera control commands are not output from the RS-422
connector when [SERIAL] is [ON].
IP [OFF, ON]
Set ON/OFF for the function which outputs with UDP the tracking data
such as Pan/Tilt/Zoom data via IP output and synchronizes it with the
GENLOCK signal. (→ page 72)
<NOTE>
• When [IP] is [ON], video transmission via IP may be delayed or the
video may suffer frame loss.
We recommend setting [IP] to [OFF] to avoid the delay or frame loss
due to the video transmission via IP.
INVERT PAN/TILT AXIS [OFF, ON]
Set whether to invert the PAN/TILT data for output in the tracking data.
OFF PAN/TILT data is not inverted.
ON PAN/TILT data is inverted for output.
CAMERA ID [0x00 to 0xFF]
Sets the Camera ID for tracking data.
Tracking data output
When [SERIAL] or [IP] of [TRACKING DATA OUTPUT] is set to [ON],
outputs the tracking data for Pan/Tilt/Zoom or other information to
link with a virtual studio system or elsewhere via serial (RS-422) or IP
output.
z Serial (RS‑422) output
• When [SERIAL] of [TRACKING DATA OUTPUT] is set to [ON], the
tracking data for Pan/Tilt/Zoom or other information is synchronized
with the GENLOCK signal and output via the serial output (RS-422).
• The tracking data is output in stream mode in a format conforming to
the free-d protocol. The message type is Type D1 (camera position/
orientation data) only.
Advanced stored data
This unit stores and outputs the following data according to the packet
structure specified in Type D1 of the free-d protocol.
Camera ID
An ID between 00h and FFh can be selected.
Camera Pan Angle
Stores the Pan angle of the unit (–175° to +175°) with the format
provided by the free-d protocol.
Camera Tilt Angle
Stores the Tilt angle of the unit (–30° to +210°) with the format
provided by the free-d protocol.
<NOTE>
• The range of the angle is limited to between –90° and +90° in the
free-d protocol. However, this unit can store greater angles than
+90° (up to +210°).
Camera Roll Angle
Stores the rotation angle (0° or 180°) corresponding to the FLIP state
(turned upside down or left-right reversed) of the unit with the format
provided by the free-d protocol.
Stores an angle of 180° in the flipped state (turned upside down or
left-right reversed) (exceeding the angle specified when [SMART
PICTURE FLIP] is [ON]), and stores 0° other than in this condition.
Camera X‑Position
Always stores 000000h.
Camera Y‑Position
Always stores 000000h.
Camera Height (Z‑Position)
Always stores 000000h.
Camera Zoom
Stores the magnification of optical zoom of this unit between 000555h
(WIDE) and 000FFFh (TELE).
<NOTE>
• The magnification of digital zoom is not stored.
71
Camera menu items (continued)
To Next Page
Loading...
