Panasonic HomeHawk KX-HNC500 - Page 31

*1 You can configure the camera so that its LED indicator does not light during normal operation or
when motion is detected. See “HD camera device profiles”, Page 171.
Floor camera LED indicator
Off R No power
R LED indicator is turned off
*1
Green
Registration successfully completed
*3
or signal level is strong
*2
Registration mode, updating
Camera is searching for your wireless router
Blinking every 1.5
seconds
Batteries for power backup are in use
Red
Registration failed
*3
, signal level is weak
*2
R Streaming data
*1
or detecting motion
*1
R Accessing microSD card (when privacy mode is off)
R Camera is out of range of your wireless router
*2
R LED lights are abnormally hot
R Wireless LAN connection failed
Yellow Not registered to your wireless router (usually for initial setup), or signal
level is good
*2
Initial setup is being performed using WPS on your router
Blue Registration to your wireless router successfully completed or camera is
on
*1
White
Privacy mode is on
*1
Accessing microSD card (when privacy mode is on)
*1 You can configure the camera so that its LED indicator does not light in most states. See “Status”,
Page 109.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 109.
*3 Lights for 3 seconds after registration is successfully completed or failed.
Shelf camera LED indicator
Off R No power
R LED indicator is turned off
*1
Green
Registration successfully completed
*3
or signal level is strong
*2
Registration mode, updating
Camera is searching for your wireless router
Red
Registration failed
*3
, signal level is weak
*2
R Streaming data
*1
or detecting motion
*1
R Accessing microSD card (when privacy mode is off)
31
Getting started with the HomeHawk!