R Camera is out of range of your wireless router
*2
R Wireless LAN connection failed
Yellow Not registered to your wireless router (usually for initial setup), or signal
level is good
*2
Initial setup is being performed using WPS on your router
Blue Registration to your wireless router successfully completed or camera is
on
*1
White
Privacy mode is on
*1
Accessing microSD card (when privacy mode is on)
*1 You can configure the camera so that its LED indicator does not light in most states. See “Status”,
Page 109.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 109.
*3 Lights for 3 seconds after registration is successfully completed or failed.
Window camera LED indicator
Off R No power
R LED indicator is turned off
*1
Green
Registration successfully completed
*3
or signal level is strong
*2
Registration mode, updating
Camera is searching for your wireless router
Red
R Registration failed
*3
R Accessing microSD card (when using 24/7 recording)
R Signal level is weak
*2
R Streaming data
*1
or detecting motion
*1
R Accessing microSD card (when not using 24/7 recording)
R Device error (fan error)
R Camera is out of range of your wireless router
*2
R Wireless LAN connection failed
Yellow Not registered to your wireless router (usually for initial setup), or signal
level is good
*2
Initial setup is being performed using WPS on your router
Blue Registration to your wireless router successfully completed or camera is
on
*1
*1 You can configure the camera so that its LED indicator does not light in most states. See “Status”,
Page 109.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 109.
*3 Lights for 3 seconds after registration is successfully completed or failed.
32
Getting started with the HomeHawk!
To Next Page
Loading...
