Panasonic Hybrid IP-PBX - Programming the IP-EXT16 Card

4.1 Programming the IP-EXT16 Card
28 Information about IP Proprietary Telephones
4.1 Programming the IP-EXT16 Card
4.1.1 Assigning the IP Addressing Information
When an IP-EXT16 card is placed on the LAN for the first time, it is necessary to assign IP addressing
information to the card. This is done by using the KX-TDA Maintenance Console.
Notes
• It is assumed that you have already installed the KX-TDA Maintenance Console to your PC.
• The contents and design of the software are subject to change without notice.
• Screen shots reprinted with permission from Microsoft Corporation.
1. Start the KX-TDA Maintenance Console from the Start
menu.
2.
a. Type the Installer Level Programmer Code
(INSTALLER).
b. Click OK.
3.
a. Click Connect → RS-232C or USB.
b. On the next screen, type the system password for
installer (default: 1234).
c. Click OK.
The program menu appears.
4.
a. Double-click Configuration.
b. Double-click Slot.
c. Click Status of the IP-EXT16 card.
d. Set the status to OUS.
e. Click Card Type of the IP-EXT16 card.
5.
a. In the IP Address box, type the IP address of the
card
*1
.
b. In the Subnet Mask box, type the subnet mask
address of the network
*2
.
c. Click OK.
d. Click Status of the IP-EXT16 card.
e. Set the status to INS.