4.3.3.2 Station Mode
After installing the software, you can use this unit in station mode of wireless LAN by the following
procedure.
1. Touch the icon ( ) on the home screen.
2. Touch [LAN mode] [Wireless LAN Station Mode].
3. Touch the icon (
) to complete your selection.
4. Touch the icon (
).
5. Touch [Wi-Fi Protected Setup (WPS)] [Push Button Configuration].
6. Press the WPS button on your wireless access point.
Note
After switching the LAN mode, connection with paired computers may be interrupted. To re-establish
connectivity with existing PC's over the LAN, the Network Scanner Select Tool should be used. For
details, refer to "4.4.3 Changing the Scanner Connected over LAN" (page 29).
4.3.3 When using this unit with a wireless LAN connection
27
To Next Page
Loading...
