8.1.3 Scanning by selecting the preset condition
Register the scan settings as a preset in advance. For details, refer to "8.1.1.9 Registering a preset" (page
63).
Operate the unit as follows.
1. Touch the Favorite button (
).
2.
Touch the icon (
).
3. Touch the preset to select.
4. Place the documents on the feed tray (page 49).
5. Press the Start/Stop button ( ) to start scanning.
• If "Confirm Output Path" in the "Preset Scan" settings is enabled, the output path will be displayed on
the LCD. Confirm the output path, and then press the Start/Stop button ( ) again.
• If "Confirm Output Path" in the "Preset Scan" settings is disabled, scanning will start.
• Remove documents after they have been scanned.
8.1.3 Scanning by selecting the preset condition
73
To Next Page
Loading...
