4. Place the documents on the feed tray with the side to be scanned facing down, and insert them in the
direction of the arrow until they stop.
• Set the leading edge of documents as shown in the illustration (A).
Note
• Place the documents as shown in the illustration.
• The document guides have a mark ( ) showing the approximate upper limit (5 mm [0.2 in.]) for
stacking documents to be scanned.
• When the paper is thin, it may not be fed properly due to curls in the paper. In that case, press the
front part of the exit support (A) to use the exit support.
Notice
• Be sure to use the exit support in the position as shown in the illustration. It may detach
from the unit if you try to pull it up more.
Operating Manual 35
Operation
To Next Page
Loading...
