Panasonic KV-S1027C - Page 66

66
F61: Front-side
black level error
51 00 00 00 1. Problem with Pixel data from
CIS (F) or from image
processing circuit
1. Check the connection and soldering condition of
the following parts.
(1) between CIS and CN1 (CONTROL Board)
2. Check the soldering condition of the following parts
and of their surrounding circuits on the CONTROL
Board.
(1) IC43(FPGA) Only for S1057C or SL1066
(2) IC2 (AFE)
(3) IC7 (D/A Conv.)
3. Monitor the following CIS Timing signals on the
CN1.
(1) CLK (CN1-5th pin) : See Fig. 10.2.1.
(2) SI (CN1-7th pin) : See Fig. 10.2.2.
4. Replace faulty parts or boards.
F62: Back-side
gain adjustment
error
52 00 00 00 1. The surface of Scanning
Glass (B) is dirty.
Clean the surface with a soft and dry cloth.
2. CIS (B) Unit does not work
properly
1. Open the ADF Door and check the position of Ref-
erence Plate (B) after power-on and the error.
(1) White background : OK
(2)Black background : Check if the Slider which
drives the Reference Plate moves smoothly after
the ADF Door opens and closes.
2. Execute Focus test in Sec.
Test (P. 47 ) to check the
waveform of CIS output.
3. Check that LED (B) lights during Focus test.
4. Check the following connections and soldering
condition on each connector.
a. CIS (B) Unit to CN2(CONTROL Board)
5. Check the power supply for LED.
(1) CN2-7th pin, F8: 7.0 V
(2) L4,L5,L8,Q10,Q11,Q12
6. Replace faulty parts or boards.
3. Problem with Pixel data from
CIS (B) or from image
processing circuit
1. Check the connection and soldering
condition of the following parts.
(1) between CIS (B)
and CN2 (CONTROL Board)
2. Check the soldering condition of the following
parts and of their surrounding circuits on the
CONTROL Board.
(1) IC43(FPGA) Only for S1057C or SL1066
(2) IC3 (AFE)
(3) IC7 (D/A Conv.)
3. Monitor the following CIS Timing signals on
the CN2.
(1) CLK (CN2-5th pin) : See Fig. 10.2.1.
(2) SI (CN2-7th pin) : See Fig. 10.2.2.
4. Replace faulty parts or boards.
F63: Back-side
black level error
53 00 00 00 Problem with Pixel data from
CIS (B) or from image
processing circuit
1. Check the connection and soldering
condition of the following parts.
(1) between CIS (B)
and CN2 (CONTROL Board)
2. Check the soldering condition of the following
parts and of their surrounding circuits on the
CONTROL Board.
(1) IC43(FPGA) Only for S1057C or SL1066
(2) IC3 (AFE)
(3) IC7 (D/A Conv.)
3. Monitor the following CIS Timing signals on
the CN2.
(1) CLK (CN2-5th pin) : See Fig. 10.2.1.
(2) SI (CN2-7th pin) : See Fig. 10.2.2.
4. Replace faulty parts or boards.
Error Code Possible Cause Check Point
Classified Code ST1 ST2 ST3 ST4