Note
• The height of the documents should not exceed the limit mark ( ) on the document guide.
Exceeding the limit mark may cause a paper jam or skewing.
• When the paper is thin, it may not be fed properly due to curls in the paper. In that case, press the
front part of the exit support (
) to use the exit support.
Notice
• Be sure to use the exit support in the position as shown in the illustration. It may detach
from the unit if you try to pull it up more.
6. Adjust the document guides ( ) to the size of the documents to be scanned.
6.2.2 Loading documents
41
To Next Page
Loading...
