14
4.5. Connecting the Unit to a Personal Computer
Connect the Power Cord (B) (except KV-SL10xx-CN), then insert the plug of the cord in the AC outlet.
Then connect the unit to a computer with the USB Cable (A).
Caution
1. Only use the Power Cord and USB Cables included with this scanner.
2. Do not connect more than 1 flatbed scanner to the same computer.
(Otherwise, the flatbed scanner you would like to use may not operate.)
3. Be sure to connect the scanner directly to the USB interface port on the PC.
If you connect the scanner to a USB hub, it is not guaranteed to work.
4. During long periods of non-use, conserve power by unplugging the Power Cord from the outlet.
While plugged in, this unit consumes 0.5 W or less of power.
4.6. Installing the Unit
Refer to the concerned pages of Operating Manual (Refer to 15. Appendix (Operating Manual P.20).)
(B)
To AC outlet
Computer
(A)
To Next Page
Loading...
