Panasonic KV-S1065C - Document Preparation

6. Connect cables.
• Connect the power cord to the AC adaptor.
• Connect the AC adaptor to the scanner.
• Plug into the AC outlet.
• Connect the USB cable to the scanner and to
your computer.
Note
• Use only with the power cord and the AC
adaptor enclosed with the unit.
• Use the USB cable enclosed with the unit.
• When the unit is not used over an extended
period of time, turn the unit off, and unplug
the power cord. The power consumption is
approximately 0.3 W when the unit is turned
off, and the AC adaptor is connected to the
AC outlet.
C
D
E
AB
AC adaptor
Power cord
To AC outlet
To computer
USB cable
7. Install the software (Page 16).
8. Press the power key to turn ON the scanner power.
• The LED (Green) will blink, and then it will
become steady.
LED (Green)
Power key
14 Installation Manual
Installation