4.2.6 Using Carrier sheet
Y
ou can use an optional carrier sheet (KV-SS076) to scan incompatible documents like very thin paper,
curled or wrinkled documents, photographs etc. For the conditions for documents when using the carrier
sheet, please refer to "4.1.2 Carrier Sheet" (page 25).
1. Set the paper path selector to Straight path (rear exit).
2. Set the manual feed selector to Manual feeding.
3. Place the carrier sheet on the feed tray with the surface to be scanned facing up.
• Adjust the document guides to the size of the carrier sheet.
• Move the document guide while pressing the lever (
) of the document guide.
4. Start scanning.
Note
• If the rollers are dirty
, the scanned image will be stretched or distorted. In such cases, clean the
rollers.
• If vertical streaks appear on the scanned image, clean the scanning glasses and the carrier sheet.
Vertical streaks that appear may be caused by scratches on the carrier sheet. If vertical streaks
appear after cleaning the scanning glasses and the carrier sheet, flip over the carrier sheet to the
other side, or replace the carrier sheet, and then scan the documents.
• If the carrier sheet does not feed well, please refer "4.2.5 When feeding stiff or thick documents"
(page 33).
4.2.6 Using Carrier sheet
34
To Next Page
Loading...
