7. Install the double feed prevention roller.
• Place the axis with the groove facing the right
side, and align
the groove with the roller mount
to install it. There are 2 grooves on the shaft.
Align the grooves with the U-shaped section on
the roller mount to install it.
Notice
• After you install the double feed prevention
roller, make sure that the shaft will not rotate
or move. If the groove is not properly
inserted in the roller mount, it may cause
double feeding or a paper jam.
8. Hold the double feed prevention roller cover and
close by pushing it into the scanner.
Notice
• Be
sure
to
close the double feed prevention
roller cover until it clicks into place. If the
double feed prevention roller cover is not
closed correctly when the front door is
closed, the double feed prevention roller
cover may break.
9. Close the front door.
• Push both sides of the front door down slowly
until it clicks into place.
Notice
• Make sure that the double feed prevention
roller cover is
closed properly before closing
the front door.
14 Installation Manual
Installation
To Next Page
Loading...
