7. Close the ADF door.
• Push both sides of the ADF door down slowly
until it clicks into place.
8. Connect the power cord and the USB cable to the
scanner.
Notice
• Use only the power cord that is provided
with the unit.
• Use the included USB cable or a certified
Hi-Speed USB 2.0 cable.
USB connector
To the computer
USB Cable
To the AC outlet
Power cord
AC inlet
9. Install software (page 17).
10. Set the power switch of the scanner to " " (ON).
• The ready indicator lights green.
Ready indicator
Power switch
Installation Manual 15
Installation
To Next Page
Loading...
