Panasonic KX-F750 - Connections and Dialing Mode Setting

Installation and Preparation
Connections and dialing mode setting
Handset
Handset cord
Connect to LINE.
Set the dialing mode to either TONE or PULSE.
(Refer to helpful hint below.)
DIALING MODE
TONE Jt PULSE
Telephone
line cord
- CT = Modular jack for single line
, (RJ11C)
| ~~ Power cord Line surge
protector
Power outlet
D (120 V, 60 Hz)
Power surge
protector
Helpful hint for setting the dialing mode:
1. Ensure that the dialing mode selector is set to TONE.
2. Lift the handset or press the SP-PHONE button, then listen for the dial tone.
3. Dial a familiar number.
4. If the call is successful, the unit is connected to a tone exchange. Leave the selector set to TONE.
5. If the call is not successful, the unit is connected to a pulse exchange. Switch the selector to PULSE.
Notes:
e We recommend the use of an exclusive power outlet to avoid interference from other equipment.
e When you operate this product, the socket outlet should be near the product and be easily accessible.
e The unit will not function during a power failure.
e For additional equipment protection, we recommend the use of a surge protector. The following type is
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
11