Panasonic KX-F750 - Voice Contact; Initiating Voice Contact

Advanced Instructions
Voice Contact
You can have a voice conversation on the same call after fax transmission or reception is completed.
This saves the extra expense and time of making a subsequent telephone call to discuss the information
sent over the fax.
Important:
e This feature works only when the other party's unit is equipped with the voice contaci/call reservation
feature.
Initiating voice contact
@ Press SP-PHONE/VOICE STDBY while
transmitting or receiving documents.
VOICE STANDBY
— Your unit will call the other party with a
distinctive ring.
€) When the other party answers, the unit will
emit a distinctive ring. While ringing, press
SP-PHONE/VOICE STDBY again or lift the
handset to start speaking.
Notes:
ejf you initiate voice contact while transmitting
documents, you can speak after all the
documents have been transmitted.
elf you initiate voice contact while receiving
documents, you can speak after the current page
of the documents is received.
e You can initiate the voice contact by lifting the
handset during transmission or reception.
eif the other party does not answer, the line will be
disconnected automatically.
Heceiving a request for voice contact
If the other party initiates voice contact, your unit will emit a distinctive ring after the transmission or
reception is completed.
When a distinctive ring is heard, press SP-PHONE/VOICE STDBY or lift the handset, then start speaking.
Note:
ejf you do not answer within 10 seconds of hearing the distinctive ring, one of the following occurs:
—when the unit is in the ANS/FAX mode, it will play back your greeting message and record the incoming
voice message.
— when the unit is in the TEL/FAX, FAX or TEL mode, the line will be disconnected.
52