Panasonic KX-F750 - Programming the Remote ANS ID; Listening to the Recorded Messages in the Common Memory

Advanced Instructions
Programming the remote ANS ID
The remote ANS ID is used to access your answering device from a remote location with a touch tone
telephone.
Choose any number from 111 to 999 except a number including “0”.
Make sure that the first 2-digit number of the remote ANS ID is different from the junk mail prohibitor ID.
Enter the desired
number (111—999).
1) MENU Press MENU. o
|
O 1.SYSTEM SET UP
o Press #10. START —— Press START/SET to
store the setting.
CR) (1) CoD REMOTE [ renore ans 1D | ID
© Press START/SET. E Press MENU to end the
START/SET Briain
Note:
e We recommend that you do not use seven (7) as an ID number, because this number is used as the
greeting message re-recording command for remote operations.
Listening to the recorded messages in the common memory ——
@ Call your unit.
—The unit will play the greeting message.
(Your phone
number) @ Press the remote ANS ID during the common
greeting message.
—A long beep and a short beep(s) will sound.
Short beep(s) indicate(s) the number of
newly recorded messages.
(Remote ANS ID) Short beeps will sound up to 8 times even if
9 or more calls are recorded.
HOHE
HBH
() bal 8) E) (s) 3 E3 9
© Press 4 to listen to newly recorded messages.
or
Press 5 or wait for 4 seconds to listen to all the
recorded messages.
Em
a
i
ag
a
i
Note:
e if you hear 6 beep tones after playing back
messages, the memory is full. You must erase
some or all messages.
If
you
want
to
listen
to
messages
in
the
mailbox
after
playing
back
messages
in
the
common
memory;
1. Press X and 1, 2 or 3 (desired mailbox number).
2. Press the mailbox password.
3. Press 4 (for new message playback) or 5 (for all message playback) to play back messages.
59