Panasonic KX-HCM280A - Page 29

Installation/Troubleshooting
[For assistance, please call: 1-800-272-7033] 29
5. When the Single Camera page is displayed, the setup is completed.
• If Security Warning window is displayed, click [Yes] (see page 32).
• See page 33 for Security Warning window when using Microsoft Windows
XP Service Pack 2.
Note
• See page 15 of the Operating Instructions on the Setup CD-ROM for the
Single Camera page.
• If you enable the Internet access to the camera, follow the procedures
below.
• When you are using a router supporting UPnP™
• When you are using a router not supporting UPnP™
Follow the procedures shown on page 26.
1. Enable the Auto Port Forwarding feature on the UPnP page (see
page 59 of the Operating Instructions on the Setup CD-ROM).
2. Register with the Viewnetcam.com service on the Viewnetcam.com
page (see page 61 of the Operating Instructions on the Setup CD-
ROM).
3. Confirm the Internet access to the camera (see page 30). If you
cannot access the camera, see page 45.
Network Camera
Zoom
Focus
ProgramPreset
Scan
Pan / Tilt
640X480
320X240
∗
Resolution
STD
- +
Brightness
Open
Short
Output
Refresh Interval
Image Quality
Favor Clarity
Favor Motion
Standard
∗
Motion
Please click here when gray color screen displayed
Running in IPv4 mode.
Alarm
kxhcm280ait.book 29 ページ ２００５年３月９日 水曜日 午後１時２３分