Installation/Troubleshooting
36
2. Make a hole for a cable.
3. Fix the rubbers and dents on the camera to the Ceiling Plate A and fix them
firmly
• Tighten the plate using a coin or similar object until the camera is secure.
4. Fix the Ceiling Plate A to the Ceiling Plate B and fix them firmly with Screws A.
Hole for a cable: 25 mm (1 inch)
65 mm (2.5 inches)
Fit the four rubbers in place.
Fit the two dents
in place.
Fit the hooks to the holes and move
in the counterclockwise direction.
Screws A
(2 pcs.)
Four Tabs
Fix firmly with Screws A.
kxhcm280ait.book 36 ページ ２００５年３月９日 水曜日 午後１時２３分
To Next Page
Loading...
