Panasonic KX-HDV100 - Ethernet Port Settings; Phy_Mode_Lan; Vlan_Enable; Vlan_Id_Ip_Phone

Value Range
• Y: Not use (use static DNS)
• N: Use DNS obtained by DHCPv6
Default Value
N
Web User Interface Reference Auto DNS via DHCP (Page 78)
5.3.3 Ethernet Port Settings
PHY_MODE_LAN
Value Format INTEGER
Description Specifies the link speed and duplex mode of the LAN port.
Value Range
• 1: Auto
• 2: 100Mbps/Full Duplex
• 3: 100Mbps/Half Duplex
• 4: 10Mbps/Full Duplex
• 5: 10Mbps/Half Duplex
Default Value 1
Web User Interface Reference LAN Port (Page 79)
VLAN_ENABLE
Value Format BOOLEAN
Description Specifies whether to use the VLAN feature to perform VoIP
communication securely.
Note
• You should specify "Y" for only one of "LLDP_ENABLE" or
"VLAN_ENABLE".
If "Y" is specified for two or more of the parameters above, the
settings are prioritized as follows:
"VLAN_ENABLE" >
"LLDP_ENABLE". Therefore, if "Y" is specified for both
"VLAN_ENABLE" and "LLDP_ENABLE", the VLAN-related
settings are used.
Value Range
• Y (Enable)
• N (Disable)
Default Value
N
Web User Interface Reference Enable VLAN (Page 80)
VLAN_ID_IP_PHONE
Value Format INTEGER
166 Administrator Guide Document Version 2015-02
5.3.3 Ethernet Port Settings