Panasonic KX-HDV100 - Phone User Interface Programming; Changing the Language for Phone User Interface Programming; Web User Interface Programming; Password for Web User Interface Programming

1.1.5 Phone User Interface Programming
You can change the settings directly from the unit.
For details about the operations, refer to the Operating Instructions on the Panasonic Web site
(® see
Introduction).
For details about additional features available with direct commands, see Section 3 Phone User Interface
Programming.
1.1.5.1 Changing the Language for Phone User Interface Programming
You can change the language used on the LCD. Because the language settings for the LCD of the unit are
not synchronized, you must set the languages individually for the unit.
For details about changing the setting, refer to the Operating Instructions on the Panasonic Web site (® see
Introduction).
1.1.6 Web User Interface Programming
After connecting the unit to your network, you can configure the unit’s settings by accessing the Web user
interface from a PC connected to the same network. For details, see Section 4 Web User Interface
Programming.
A
B
D
C
A. Router
B. Switching Hub
C. PC
D. KX-HDV100
1.1.6.1 Password for Web User Interface Programming
To program the unit via the Web user interface, a login account is required. There are 2 types of accounts, and
each has different access privileges.
• User: User accounts are for use by end users. Users can change the settings that are specific to the unit.
24 Administrator Guide Document Version 2015-02
1.1.6 Web User Interface Programming