Panasonic KX-HDV100 - Auto DNS Via DHCP; Dns1; Dns2; Ipv6

Default Value Not stored.
Configuration File Reference STATIC_GATEWAY (Page 162)
Auto DNS via DHCP
Description Selects whether to enable or disable the DNS server obtained by
DHCPv4.
Note
• This setting is available only when [Connection Mode] is set
to [DHCP].
Value Range
• Yes: Use DNS obtained by DHCPv4
• No: Not use (use static DNS)
Default Value Yes
Configuration File Reference DHCP_DNS_ENABLE (Page 163)
DNS1
Description Specifies the IP address of primary DNS server for IPv4.
Value Range Max. 15 characters
n.n.n.n [n=0–255]
Default Value Not stored.
Configuration File Reference USER_DNS1_ADDR (Page 163)
DNS2
Description Specifies the IP address of secondary DNS server for IPv4.
Value Range Max. 15 characters
n.n.n.n [n=0–255]
Default Value Not stored.
Configuration File Reference USER_DNS2_ADDR (Page 163)
4.3.1.3 IPv6
Connection Mode
Description Selects the IP address setting mode for IPv6.
Value Range
• Static
• DHCP
• Stateless Autoconfiguration
76 Administrator Guide Document Version 2015-02
4.3.1 Basic Network Settings