Panasonic KX-HDV100 - Auto DNS Via DHCP; Dns1; Dns2; Ethernet Port Settings

Auto DNS via DHCP
Description Selects whether to enable or disable the DNS server obtained by
DHCPv6.
Note
• This setting is available only when [Connection Mode] is set
to [DHCP].
Value Range
• Yes: Use DNS obtained by DHCPv6
• No: Not use (use static DNS)
Default Value Yes
Configuration File Reference DHCP_DNS_ENABLE_IPV6 (Page 165)
DNS1
Description Specifies the IP address of primary DNS server for IPv6.
Value Range Max. 39 characters
n:n:n:n:n:n:n:n [n=0-FFFF, abbreviation available]
Default Value Not stored.
Configuration File Reference USER_DNS1_ADDR_IPV6 (Page 165)
DNS2
Description Specifies the IP address of secondary DNS server for IPv6.
Value Range Max. 39 characters
n:n:n:n:n:n:n:n [n=0-FFFF, abbreviation available]
Default Value Not stored.
Configuration File Reference USER_DNS2_ADDR_IPV6 (Page 165)
4.3.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports, LLDP and the VLAN settings.
78 Administrator Guide Document Version 2015-02
4.3.2 Ethernet Port Settings