Note
• When
you change the settings on this screen and click [Save], after the message "Complete" has been
displayed, the unit will restart automatically with the new settings applied. If a unit is on a call when
"Complete" has been displayed, the unit will restart after the unit returns to idle.
4.3.2.1 Link Speed/Duplex Mode
LAN Port
Description Selects the connection mode (link
speed and duplex mode) of the LAN
port.
Value Range
• Auto Negotiation
• 100Mbps/Full Duplex
• 100Mbps/Half Duplex
• 10Mbps/Full Duplex
• 10Mbps/Half Duplex
Default Value Auto Negotiation
Configuration File Reference PHY_MODE_LAN (Page 166)
4.3.2.2 LLDP
Enable LLDP
Description Selects whether to enable or disable the LLDP-MED feature.
Note
• You should specify "Yes" for only one of "Enable LLDP", or
"Enable VLAN".
• If "Yes" is specified for two or more of the parameters above,
the settings are prioritized as follows:
"Enable VLAN" >
"Enable LLDP". Therefore, if "Yes" is specified for both
"Enable VLAN" and "Enable LLDP", the VLAN-related
settings are used.
Document Version 2015-02 Administrator Guide 79
4.3.2 Ethernet Port Settings
To Next Page
Loading...
