4.2.3.1 VoIP Status
Line No.(1–n)
*1
Description Indicates the line number to which a phone number is assigned
(reference only).
Value Range Line 1–Line n
*1
The number of lines available varies depending on the phone being used.
Phone Number
Description Indicates the currently assigned phone numbers (reference only).
Note
• The corresponding field is blank if a line has not yet been
leased or if the unit has not been configured.
Value Range Max. 32 digits
VoIP Status
Description Indicates the current VoIP status of each line (reference only).
Value Range
• Registered: The unit has been registered to the SIP server, and the
line can be used.
• Registering: The unit is being registered to the SIP server, and the
line cannot be used.
• Blank: The line has not been leased, the unit has not been
configured yet, or a SIP authentication failure has occurred.
Note
• Immediately after starting up the unit, the phone numbers of
the lines will be displayed, but the status of the line may not be
displayed because the unit is still being registered to the SIP
server. To display the status, wait about 30 to 60 seconds, and
then click [Refresh] to obtain updated status information.
4.3 Network
This section provides detailed descriptions about all the settings classified under the [Network] tab.
4.3 Network
66 Administrator Guide Document Version: 2017-07
To Next Page
Loading...
