Value Range 0, 200–2000 (0: No tone)
Note
• If the
value for this setting is "480,620", the unit will use a mixed
signal of a 480 Hz tone and a 620 Hz tone.
Default Value 425,0
Configuration File Reference BUSY_TONE_FRQ (Page 285)
Tone Timings
Description Specifies the pattern, in milliseconds, of busy tones using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 60,330,270
Configuration File Reference BUSY_TONE_TIMING (Page 286)
4.6.5.3 Ringing Tone
Tone Frequencies
Description Specifies the dual-tone frequencies,
in hertz, of ringback tones using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Note
• If the
value for this setting is "440,480", the unit will use a mixed
signal of a 440 Hz tone and a 480 Hz tone.
Default Value 425,0
Configuration File Reference RINGBACK_TONE_FRQ (Page 287)
Tone Timings
Description Specifies the pattern, in milliseconds, of ringback tones using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Document Version 2015-12 Administrator Guide 149
4.6.5 Tone Settings
To Next Page
Loading...
