Default Value Auto Negotiation
Configuration File Reference PHY_MODE_PC (Page 185)
4.3.2.2 LLDP
Enable LLDP
Description Selects whether to enable or disable the LLDP-MED feature.
Note
• You should specify "Yes" for only one of "Enable LLDP", or
"Enable VLAN".
• If "Yes" is specified for two or more of the parameters above,
the settings are prioritized as follows:
"
Enable VLAN" >
"Enable LLDP". Therefore, if "Yes" is specified for both
"Enable VLAN" and "Enable LLDP", the VLAN-related
settings are used.
Value Range
• Yes
• No
Default Value Yes
Configuration File Reference LLDP_ENABLE (Page 186)
Packet Interval
Description Specifies the interval, in seconds, between sending each LLDP frame.
Value Range 1–3600
Default Value 30
Configuration File Reference LLDP_INTERVAL (Page 187)
PC VLAN ID
Description Specifies the VLAN ID for the PC when LLDP is on.
Value Range 0–4094
Default Value 0
Configuration File Reference LLDP_VLAN_ID_PC (Page 187)
PC Priority
Description Specifies the VLAN Priority for the PC when LLDP is on.
Value Range 0–7
Document Version 2015-12 Administrator Guide 83
4.3.2 Ethernet Port Settings
To Next Page
Loading...
