Panasonic KX-HDV430 - Network Phonebook (Common); SIP Settings

7. 5.3.19 Network Phonebook (Common)
Add the following configuration parameter.
NW_PHONEBOOK_ADVANCED_SERACH
Value Format
Description
Value Range
Default Value
8. 5.3.22 SIP Settings
Add the following configuration parameter.
SEND_180_ALERT_ENABLE
Value Format
Description
Value Range
Default Value
9. 5.3.27 SRTP Settings
Change the Value Range in " SRTP_CONNECT_MODE_n " on page 259.
(Before)
Value Range
(After)
Value Range
Specifies whether to send 180 before an alert.
・Y: Send 180
・N: Do not send 180
N
• 0: SRTP
• 1: RTP/SRTP
• 2: SRTP&RTP(Panasonic PBX only)
Note
• 0: Use only SRTP for outgoing and incoming calls.
• 1: Use only RTP for outgoing calls, and RTP or SRTP for incoming calls.
• 2: Use RTP or SRTP for both outgoing and incoming calls.
This value is valid only when the unit is connected to a Panasonic PBX.
"SRTP_MIX_TRANSFER_ENABLE_n" must also be set to "Y".
• 0: SRTP
• 1: RTP/SRTP
• 2: SRTP & RTP (Panasonic PBX only)
• 3: SRTP & RTP (RTP/AVP, a=crypto)
Note
• 0: Use only SRTP for outgoing and incoming calls.
• 1: Use only RTP for outgoing calls, and RTP or SRTP for incoming calls.
• 2: Use RTP or SRTP for both outgoing and incoming calls.
This value is valid only when the unit is connected to a Panasonic PBX.
"SRTP_MIX_TRANSFER_ENABLE_n" mustalso be set to "Y".
• 3: If you are using "RTP/AVP" and append "a=crypto", and the response
message includes "a=crypto", the conversation will be established
with SRTP. If "a=crypto" is not included, the conversation will be
established with RTP.
BOOLEAN
Specifies whether to perform a narrowing search with the LDAP phonebook.
・Y: Enable
・N: Disable
N
BOOLEAN