Panasonic KX-HN3001W

3 Drive the supplied screw into the camera
un
it.
1
1
Supplied screw (page 9)
4 Dri
ve the screws (not supplied) into the
wall.
2
Longer than 20 mm (
25
/32 inches)
3
Space 1.3 mm (
1
/32 inches)
2 3
Note:
R Use the following template when
determining the location of the screw
holes.
(1 / inches)
31 mm
7
32
5 Mount the camera unit to the wall.
4
Screws
5
31 mm (1
7
/32 i
nches)
4
5
6 Adjust the angle of the camera unit by
us
ing MFN, MEN, MDN, or MCN on the monitor
unit.
Reattaching the camera base
1 Tak
e the camera unit off from the wall.
2 Remove the screw and then remove the
wall mounting adaptor from the camera
unit.
1
1
Supplied screw (page 9)
3 Att
ach the camera base to the camera
unit.
4 Drive the supplied screw into the camera
un
it.
1
1
Supplied screw (page 9)
For assistance, please visit http://shop.panasonic.com/support
13
Getting Started
HN3001(enen)0215ver.520.pdf13 2018/02/1510:07:59