Blue
Normal operation, connected to wireless router
*1
, privacy shutter is open
White
Normal operation, connected to wireless router
*1
, privacy shutter is closed
Camera is searching for wireless router
Green Initial setup required
Initial setup is in progress with mobile device connected
Initial setup is starting
Red
Motion detected
*1
, or camera is starting up
Live images are being viewed or recorded, or camera is starting up
Device malfunction
*1 You can configure the camera so that its LED indicator does not light during normal operation or
when motion is detected. See “HD camera device profiles”, Page 130.
Floor camera LED indicator
Off R No power
R LED indicator is turned off
*1
Green
Registration successfully completed
*3
or signal level is strong
*2
Registration mode, updating
Camera is searching for your wireless router
Blinking every 1.5
seconds
Batteries for power backup are in use
Red
Registration failed
*3
, signal level is weak
*2
R Streaming data
*1
or detecting motion
*1
R Accessing microSD card (when privacy mode is off)
R Camera is out of range of your wireless router
*2
R LED lights are abnormally hot
R Wireless LAN connection failed
Yellow Not registered to your wireless router (usually for initial setup), or signal
level is good
*2
Initial setup is being performed using WPS on your router
Blue Registration to your wireless router successfully completed or camera is
on
*1
White
Privacy mode is on
*1
Accessing microSD card (when privacy mode is on)
27
Getting started with the HomeHawk!
To Next Page
Loading...
