6
LED indicator Status
Off • No power
• LED indicator is turned off *
1
Yellow lit Not registered to your wireless router (usually for initial setup) or signal level is good *
2
blinking slowly Initial setup is being performed using WPS on your router
Green lit • Registration successfully completed
*
3
• Signal level is strong
*
2
blinking slowly Registration mode or updating
blinking quickly Camera is searching for your wireless router
Blue lit Connected to the wireless router and camera is on
Red lit • Registration failed *
3
• Accessing microSD card (when using 24/7 recording)
• Signal level is weak *
2
blinking • Camera is out of range of your wireless router *
2
• Wireless LAN connection failed
• Device error (fan error)*
4
blinking slowly • Streaming data
*
1
or detecting motion *
1
• Accessing microSD card (when not using 24/7 recording)
*1 You can congure the camera so that its LED indicator does not light during normal operation from the
camera settings of the app. For more information‚ access the User’s Guide (page 3).
*2 The signal level (strong‚ good‚ weak‚ out of range) is shown for 3 seconds after pressing
SETUP button.
*3 Lights for 3 seconds after registration is successfully completed or failed.
*4 Unplug the camera and then plug it in again. If the message is still displayed, contact an authorized service
center.
To Next Page
Loading...
