Panasonic KX-HTS32 - Network Configuration-[6-6] Wireless-MAC Filter; Network Configuration-[6-7] Wireless-Device Association

Screen / Tab Setting item Description Input Type Note
Push Button
Configuration
(PBC) Method
Click "start PBC", then
start PBC on the device
you want to connect to the
router within two minutes.
-
3.5.5 Network Configuration—[6-6] Wireless—MAC Filter
The wireless MAC filter settings can be programmed.
Screen / Tab Setting item Description Input Type Note
6.MAC Filter
- WLAN
MAC Control
AP name Displays the AP name. -
Access Control List
Mode(ACL Mode)
Types of Access Control Radio
MAC Address To enter the MAC address
to be used in the MAC
filter.
MAC
Address2
This feature is not
available, when
Disable is selected in
Access Control List
Mode(ACL Mode).
Remove Remove the selected
MAC address for control.
Check
3.5.6 Network Configuration—[6-7] Wireless—Device
Association
You can view a list of devices associated with the WLAN.
Screen / Tab Setting item Description Input Type Note
6.Device
Association -
WLAN
Device
Association
List
SSID Service Set Identifier. -
Max. Signal
Level@antenna
[dBm]
Indicates the maximum
signal level.
-
MAC Address MAC address of the
associated station.
-
IP Address IP address of the
associated station.
-
RSSI1 [dBm] Displays the RSSI level of
the device that is
connected to the Wireless
LAN.
-
RX Rate [Mbit/s] Displays the RX Rate of
the device that is
connected to the Wireless
LAN.
-
TX Rate [Mbit/s] Displays the TX Rate of
the device that is
connected to the Wireless
LAN.
-
3.5.5 Network Configuration—[6-6] Wireless—MAC Filter
Programming Item List 71