6.1.4 Restarting the PBX
If the PBX does not operate properly, restart the PBX using Web Maintenance Console or switch the power
to OFF then ON. Before restarting the PBX, try the system feature again to confirm whether there definitely
is a problem or not.
Note
• Restarting the PBX causes the following:
– Audio data being recorded
– System data being saved
– Data being transferred to PBX
– Calls on hold are terminated.
– Calls on exclusive hold are terminated.
– Calls in progress are terminated.
– Call park is cleared.
Other data stored in memory, except the above, are not cleared.
• The data synchronicity cycle for "operation data" that is presently running and "system data" stored in
the system's storage is 30 minutes. For that reason, when restarting the PBX within 30 minutes after
operation data has been changed, on occasion, the changed operation data will not have been saved
in the system data. Please verify the system data after restarting the PBX.
Operation
For details about the system reset, refer to "4.3.4 Maintenance—[2-4] System Control—System Reset" in
the Programming Item List.
6.1.4 Restarting the PBX
110 Getting Started
To Next Page
Loading...
