Removing the Cable Cover
1. Slide out the cable cover until the end and open it. Open the cable cover turning 90 degrees as shown
below.
2. Holding the cable cover open at about a 90 angle, remove the cable cover by pushing it in the direction
of the arrow as shown below.
Attaching the Cable Cover
1. Fit the cable cover to the main unit as shown below, and then close the cable cover.
CAUTION
For safety reasons, fix the front cover and cable cover of the PBX with screws.
Note
Be careful not to pinch your fingers during operation.
3.2.3 Opening/Closing the front cover
42 Getting Started
To Next Page
Loading...
