Panasonic KX-HTS824 - Placing the PBX on a Desktop

• If you prefer, you can cut the other side of the cable cover and run the cables through that
opening. For safety reasons, smooth the cut edges.
Note
Use plastic nippers. We do not recommend using a knife such as a retractable utility knife.
Cut Here
• When there are too many cables to fully slide in the cable cover, leave the cable cover slid open,
and tighten the screws with the cable cover in that position.
CAUTION
For safety reasons, fix the front cover and cable cover of the PBX with screws.
3.2.7 Placing the PBX on a Desktop
When placing the PBX on a desktop, make sure to follow these instructions.
WARNING
Be careful not to drop any components. Dropping components may damage them or cause an
injury.
3.2.7 Placing the PBX on a Desktop
50 Getting Started