Panasonic KX-HTS824 - Page 22

[Flow Chart]
A trunk call is received.
Is there
Caller ID?
No
Yes
Incoming Call
Block when No
Caller ID?
Disable
Caller ID Modification by Length of Digits
Leading Caller ID matches
(Area Code/Long Distance)
Enable
Leading
number check
Leading Caller ID
does not match
Speed Dial list
Not registered in Speed Dial list (Or there is no Caller ID)
Incoming
call
destination
setting
Incoming call
destination
has been set
Name list
Name
setting
Name setting
has not
been made
Name setting
has been made
Incoming call
destination has
not been set
Incoming call
destination list
Incoming call
destination set as
"Disconnect"
Busy Tone
Name setting
has been made
Call the set extension
number
(Caller name notified)
Call the set extension
number
(Caller number notified)
DDI/DIL incoming calls
(Caller number and name
notified)
DDI/DIL incoming calls
(Caller number notified or
not notified)
Name setting
has not been made
Name
setting
Registered in
Speed Dial list
Modified
number
Caller ID Modification
by leading numbers
(Deletes leading numbers:
0-6 digits)
Caller ID Modification
by leading numbers
(Adds leading numbers:
0-4 digits)
Adding the Idle
Line Access
(Local Access) number
Ex.) Caller ID: 81-50-1234-5678
• Remove the first 2 digits.
50-1234-5678
Ex.) Caller ID: 81-50-1234-5678
• Add "0" as the first digit.
050-1234-5678
Ex.) Caller ID: 81-50-1234-5678
• Add "9" as the first digit.
9-050-1234-5678
Important
FWD No Answer Time is used as the timer for forced call disconnection. For more information, refer to
3.1.9 Call Forwarding (FWD).
3.1.1 Calling Line Identification (CLI) Distribution & Call Block
22 Feature Manual