PIL Reference
2.3.1 PBX Configuration—[2-1] Extension—Port
3.8.2 Call Transfer-Unscreened
Description
This feature transfers a trunk or an extension in a conversation to another extension without speaking to the
other party at the transfer destination, with the caller being transferred hearing a ring back tone while the
transfer destination is being called.
Call Transfer—Unscreened is also known as Call Transfer without Announcement.
Operation
Perform Call Transfer-Unscreened using the following procedure:
1. Put the current call on Consultation Hold by executing the following operations:
SLT: Hooking
SIP: Press the [TRANSFER] button
2. After a dial tone is heard, make a call to the transfer destination.
3. Before the transfer destination answers, go on-hook.
Perform Cancel Call Transfer-Unscreened using the following procedure:
SLT: Hooking.
SIP extension: Press the [CANCEL] button twice.
[Transfer Recall]
• If a transfer destination does not answer within a certain length of time, the call will ring at the extension
of the person who made the transfer operation.
Conditions
Conditions Note
The following cannot be set as transfer destinations:
• DISA (Refer to 3.1.4 DISA (Direct Inward System Access))
• Meet Me (Refer to 3.9.2 Meet-me conference)
• Doorphone (Refer to 3.11.1 Doorphone Call)
• Built-in VM (Refer to 5 Voice Mail Features)
• Paging (Refer to 3.10 Paging Features)
The FWD setting for the transfer destination extension is enabled. If
the FWD destination of the Transfer destination is DISA or Meet-me,
call transferring will be restricted.
Reference:
3.1.4 DISA (Direct Inward System
Access)
3.9.2 Meet-me conference
A party who is put on Consultation Hold will hear Music on hold
(MOH).
Refer to 3.7.3 Music on Hold.
3.8.2 Call Transfer-Unscreened
Feature Manual 55
To Next Page
Loading...
