Original document Page layout
“4 in 1”
“8 in 1”
5.2.4 Poster feature
You can make copies divided into 2 (“1 X 2”), 4 (“2 X
2”) or 9 (“3 X 3”) sections to make enlarged copies of
the individual sections. You can then glue them together
to make a poster.
1 Set the original (page 18).
2 Press MPage LayoutN repeatedly to select “PAGE
LAYOUT”.
3 Press MCN or MDN repeatedly to select “POSTER”.
A MSetN
4 Press MCN or MDN repeatedly to select “1 X 2”, “2 X
2” or “3 X 3”. A MSetN
5 If necessary, enter the number of copies (up to 99).
A MStartN
6 After you finish copying, press MStopN to reset this
feature.
Note:
R You can save the previous page layout setting
(feature #467 on page 54).
5.2.5 N in 1 feature
You can save paper by copying 2, 4 or 8 pages onto 1
page. The documents will be reduced to fit the recording
paper.
1 Set the original (page 18).
R To make a portrait copy, set the original in portrait
direction. To make a landscape copy, set the
original in landscape direction.
2 Press MPage LayoutN repeatedly to select “PAGE
LAYOUT”.
3 Press MCN or MDN repeatedly to select “N in 1”.
A MSetN
4 Press MCN or MDN repeatedly to select the number of
original documents from “2 in 1”, “4 in 1” or “8
in 1”. A MSetN
5 Press MCN or MDN repeatedly to select the layout from
“PORTRAIT” or “LANDSCAPE”. A MSetN
6 If necessary, enter the number of copies (up to 99).
7 MStartN
R The unit will scan 1 page.
8 Place the next document on the scanner glass and
press MSetN. Repeat this until all the documents are
scanned.
R The unit will start copying.
R You can press MStartN anytime to start copying.
9 After you finish copying, press MStopN to reset this
feature.
Original document Page layout
“2 in 1” “PORTRAIT”
“LANDSCAPE”
“4 in 1” “PORTRAIT”
“LANDSCAPE”
31
5. Copier
To Next Page
Loading...
