* The pictured model is KX-MB1520.
1 If the MFaxN light is OFF, turn it ON by pressing
MFaxN repeatedly.
2 Set the original (page 18).
3 If necessary, change the resolution and contrast
according to the type of document.
R To select the contrast, see page 38.
R To select the resolution, see page 38.
4 Dial the fax number.
5 Press MStartN to scan the document into memory.
Wait until “SCAN:PRESS SET” “SEND:PRESS
START” is displayed.
6 To send a single page:
Press MStartN.
To send multiple pages:
1. Place the next page on the scanner glass. A
MSetN
R To send more pages, repeat this step.
2. When all pages are scanned, press MStartN.
Note:
R To stop sending, see page 65.
R While talking to the other party using the
MSP-PhoneN, you can send a fax using the scanner
glass by pressing
MStartN, and then M1N (To receive
a fax, press M2N).
R You can change the default operation mode (feature
#463 on page 54) and the timer before returning to
the default operation mode (feature #464 on
page 55).
To select the contrast
Adjust this setting depending on the darkness or
lightness of the document. 5 levels (low to high) are
available.
1. Press MQualityN repeatedly to display “CONTRAST”.
2. Press MCN or MDN to change the contrast.
3. MSetN
Note:
R You can save the previous contrast setting (feature
#462 on page 54).
To select the resolution
1. Press MQualityN repeatedly to display
“RESOLUTION”.
2. Press MCN or MDN to change the resolution.
– “STANDARD”: For normal-sized characters.
– “FINE”: For small-sized characters.
– “SUPER FINE”: For very small-sized characters.
– “PHOTO”: For photographs, shaded drawings,
etc.
3. MSetN
R Using the “FINE”, “SUPER FINE” and “PHOTO”
settings will increase transmission time.
To redial the last number
MRedialN
R If the line is busy, the unit will automatically redial the
number 2 or more times.
Note:
R To stop sending, see page 65.
Reserving the fax transmission (Dual Access)
You can reserve a fax transmission even when the unit
is just receiving a fax or sending a fax from memory.
– Up to 3 reservations when sending
– Up to 4 reservations when receiving
1. Set the original during fax reception or fax memory
transmission.
2. Enter the fax number using the dial keypad or
phonebook.
3. When using the scanner glass, press MStartN. The
unit will scan 1 page. Place the next document on the
scanner glass and press MSetN. Repeat this until all
the documents are scanned, then press MStartN.
When using the automatic document feeder,
press MStartN (KX-MB1530 only).
R If the document exceeds the memory capacity, the
reservation for that document will be cancelled. You
must send the entire document manually.
38
6. . Fax (KX-MB1520/KX-MB1530 only)
6. Fax (KX-MB1520/KX-MB1530 only)
To Next Page
Loading...
