6.6 Receiving a fax automatically :
Auto answer ON
R A4 or letter size recording paper can be used.
6.6.1 Activating FAX ONLY mode
Press MFax Auto AnswerN repeatedly to display “FAX
ONLY MODE”.
R The display will show the ring count in FAX ONLY
mode. If you wish to change it, press MCN or MDN
repeatedly to display the desired setting, and press
MSetN.
R The MFax Auto AnswerN light turns ON.
* The pictured model is KX-MB1520.
How faxes are received
When receiving calls, the unit will automatically answer
all calls and only receive fax documents.
Note:
R The number of rings before a call is answered in FAX
ONLY mode can be changed (feature #210 on
page 53).
6.7 Receiving a fax manually :
Auto answer OFF
R A4 or letter size recording paper can be used.
6.7.1 Activating TEL mode
1 Make sure feature #404 is set to “TEL” beforehand
(page 56).
2 Press MFax Auto AnswerN repeatedly to display
“TEL MODE”.
R The MFax Auto AnswerN light turns OFF.
* The pictured model is KX-MB1520.
Note:
R If you do not answer the call within 10 rings, the unit
will temporarily switch to fax reception. The other
party can then send a fax.
How to receive phone calls and faxes
1. Press MSP-PhoneN to answer the call.
2. When:
– document reception is required,
– a fax calling tone (slow beep) is heard, or
– no sound is heard,
press MStartN, and then M2N.
Note:
R To stop receiving, see page 65.
How to receive faxes with an extension telephone
If you have another telephone connected to the [EXT]
jack or the same line (extension telephone), you can use
the extension telephone to receive faxes.
1. When the extension telephone rings, lift the handset
of the extension telephone.
2. When:
– document reception is required,
– a fax calling tone (slow beep) is heard, or
– no sound is heard,
43
6. Fax (KX-MB1520/KX-MB1530 only)
To Next Page
Loading...
